 |
| |
If you have any problem during your installation and using after you buy it, please check its question list, you will get detail answer. If you have more question during inuse, you can call our free hotline, we should give you a satisfactory answer.
|
-
- Faucet – Leaking
- Reasons：
1. Poor Water
Poor water resulting in cartridge with garbage..
2. Scratch
The seal ceramic plate of cartridge during the using, it caused scatch what attrited from solid things, so it can’t be sealed, and be leaking.
3. Pipeline connection
Connection water leakage between inlet hose and tap body, the major cause is installation unsuitable.
-
- Faucets- cover with wax can prevent plaring part rust.
- Reasons：The cause: as long as there are relation between the utensils with the water, part of the above are mostly bright silver nickel-chrome plating done deal. The main purpose of decorative plating and rust-proof, but it does not mean that no matter stood and will never rust. Plating layer, there are many holes in the naked eye can not distinguish between pinhole if the wet gas or corrosive gas from here ran in, under the material will rust and seeping to the surface. Such as these often come across some of the tap it is easy to rust, beacause the hand of oil will unknowingly spread throughout the faucet slowly touch, which covers the hole, tap the bottom of the plating layer of corrosion material. Thus each month by cover wax of some these plating, we can pretect the faucet electroplating layer.
-
- Thermostatic leading cause resulting fits and starts.
- Reasons：
The cause: 1. too little hot water
Occurred mainly in the use of gas-tape water heater users, and mostly occurs during the summer. As the hot summer, the relatively small amount of hot water heater is very easy to satisfy and meet only after the cessation of firing. Such as lack the hot water when the ignition again. So repeated ignition, flame, ignition, resulting in water supply, no, there is, resulting in water fits and starts. Solution: the water heater of the fire and temperature is relatively lower.
2. underpower
Supporting water heater power shortage, the required heat can not be met, the solution: replace the high-power water heater spam filers are blocking apam blocking, resulting in reduced water pressure. Solution: remove angle valve department filter. Faucet-shower-tub shower.
-
- Solution: remove angle valve department filter.
- Reasons：The cause: due to shower, tub with the tap of the switch is controlled by water pressure, if the inlet water pressure is too low (does not meet the required water pressure), will cause the switch leading from the valve while being the top, but not completely sealed to more than imagination. The solution: increase water pressure, for example, increase booster pump from pipeline.
-
- Faucet- why hand on the “cold” position will also have hot water come out?
- Reasons：Cause reasons: mainly occurred in the use of gas-type water heater user, mainly due to high water pressure, “hot” pipe out of the water has gone down, but the pressure is still enough to open top-water heater valve pressure, allowing water heater ignition, work, so, hand in the “cold” position will also have hot water.
|
| |
|
|
